Attention

TYPO3 v8 has reached its end-of-life March 31st, 2020 and is not maintained by the community anymore. Looking for a stable version? Use the version switch on the top left.

There is no further ELTS support. It is recommended that you upgrade your project and use a supported version of TYPO3.

RESTORE_REGISTER

This unsets the latest changes in the register-array as set by LOAD_REGISTER.

Internally registers work like a stack where the original register is saved when LOAD_REGISTER is called. When a RESTORE_REGISTER cObject is called, the last element is pulled off that stack and the register is replaced with the content of the previous element.

RESTORE_REGISTER has no properties.

Example:

The following example shows how LOAD_REGISTER and RESTORE_REGISTER can be used to load values into the register and to restore previous values again.

# Put first block into the register
10 = LOAD_REGISTER
10 {
  myTextRegister.cObject = COA
  myTextRegister.cObject {
    10 = TEXT
    10.value = This is text in the first block.
    10.stdWrap.wrap = <p>|</p>
  }
}
# Put second block into the register
20 = LOAD_REGISTER
20 {
  myTextRegister.cObject = COA
  myTextRegister.cObject {
    10 = TEXT
    10.value = This is text originally used in the second block...
    10.stdWrap.wrap = <p>|</p>
  }
}
# Put third block into the register using text from the second block.
30 = LOAD_REGISTER
30 {
  myTextRegister.cObject = COA
  myTextRegister.cObject {
    # Get the current text from myTextRegister:
    # "This is text originally used in the second block..."
    10 = TEXT
    10.stdWrap.data = register:myTextRegister
    10.stdWrap.append = TEXT
    10.stdWrap.append.value = (but now used in the third block).
    20 = TEXT
    20.value = This is a second text in the third block.
    20.stdWrap.wrap = <p>|</p>
  }
}
# Up to this place no actual output has been produced.

# Outputs block 30 "This is text originally used in the second block...
# (but now used in the third block). This is a second text in the third block."
40 = TEXT
40.stdWrap.data = register:myTextRegister

# Outputs block 20 "This is text originally used in the second block..."
50 = RESTORE_REGISTER
60 = TEXT
60.stdWrap.data = register:myTextRegister

# Outputs block 10 "This is text in the first block."
70 = RESTORE_REGISTER
80 = TEXT
80.stdWrap.data = register:myTextRegister